Most of the watches we sell are LEVER SET.
If you have purchased one of these, and are unsure how to set time, refer to the above pictures.
PLEASE REFER TO THE ABOVE PHOTOS BEFORE ATTEMPTING
TO SET YOUR RAILROAD WATCH FOR THE FIRST TIME.
TO SET TIME:
Unscrew the bezel (part over the dial) or on a hunter, simply push down on crown to open front of case & expose the dial.YOU WILL SEE A LEVER AT 1-2 O'CLOCK (Picture #1..or at 5 on hunting case watches)
(Refer to the "notch" in the case...that is usually the lever location.)SLIDE THE LEVER OUT OF THE WATCH using your thumbnail as shown above (Picture #2). It is best to have the watch lying on a flat surface the first time.
DO NOT PULL UP ON THE LEVER! This will break the lever off.Using the crown (winder), set the time to your location.
Lightly push the lever back in to it's original location. Screw the bezel back on clockwise.
IMPORTANT!!: Make sure lever is pushed back in before screwing bezel back on!
THAT'S IT!!! After you do this once, you will see how easy it is to do again.
Call us if there are any questions.
View Our Entire Current Inventory at Time Machine
Go to Home Page here or use your browser's back button.